Tip-Ons Glued - Perfect Bound

Saddle  Stitched || Perfect Bound  || Secondary  Process || Wet Sachet

It is not possible to tip onto the first or last page of a perfect bound product without incurring secondary process costs.

If the product is knocked to the foot then the tip-on is applied to the left hand page.

If the product is knocked to the head then the tip-on is applied to the right hand page.

A tip on must be positioned a minimum of 20mm from any edge of the carrier product.

A perforation on a single sheet, which runs parallel to the edge facing the spine of the carrier product, must be a minimum 30mm from the edge of the tip-on. This area is the suction area in the mechanical feeding process.

Pre-punched stickers must be a minimum of 30mm from the edge, which runs parallel to the spine of the carrier product. Excessive adhesive is not permitted to emerge.

All tip-ons must conform to the maximum and minimum sizes as shown below which must be strictly adhered to:

Maximum Size the tip-on must be is 210mm x 210mm.

Minimum Size the tip-on must be is 100mm x 60mm.

A single sheet must be a minimum stock weight of 115gsm.

The following are the maximum permissible tip-on weights allowed in relation to the stock weight of the carrier product being tipped onto:

Tip-ons incur a slow down factor due to the mechanical process. Additional time will need to be added to the production schedule.

Hannanprint Conditions
All inserts are subject to the approval of Hannanprint who reserves the right to refuse any material considered unsuitable for publication.
Whilst every effort will be made to process inserts as ordered, no liability can be accepted for misplacement or omission.
Hannanprint NSW will not guarantee the level or response associated with an insert.
Advertising agents and advertisers accept responsibility for the contents of their inserts and agree to indemnify Hannanprint NSW against any claims or proceedings arising from publication of such inserts.